Encore Networks VSR-1200 Instalační příručka stáhnout pdf (Strana 3)

VSR-1200™ and RDU™ Installation and Quick Configuration Guide Page 3

Figure 2-2. VSR-1200 Chassis, Rear

4 If this VSR-1200 uses one or two Remote Data Units™ (RDUs, Figure 2-3), connect each

RDU’s Ethernet port (Figure 2-4) to a separate Ethernet port on the VSR-1200’s DMZ

switch (Figure 2-2).

Figure 2-3. Remote Data Unit, Front

Figure 2-4. Remote Data Unit, Rear

5 Connect the VSR-1200’s ports to their network devices.

6 If one or more RDUs are connected to the VSR-1200, connect each RDU’s serial ports to

their network devices.

7 Connect each power supply on the VSR-1200 chassis to an outlet supplying

100–240 VAC at 47–63 Hz.

8 Use the Supervisory cable and adapter to connect the device’s Supervisory port to your

PC’s COM port.

Note: An eight-pin modular (RJ-45) to DB-9 adapter is the standard adapter to connect

the Supervisory cable to a PC. This adapter is shipped with the unit. The following

alternate adapters are also available. (Contact Encore Networks, Inc., if you need either

of these adapters.)

• An RJ-45 to DB-25 adapter for connection to most asynchronous terminals

• An RJ-45 to DB-25 modem adapter to connect a modem, for out-of-band management

or remote configuration

1 2 3 4 5 6 7 8 ... 25 26

Žádné komentáře

Encore Networks VSR-1200 Instalační příručka Strana 3